Trackspec SCCA Legal Hood Vents - 200 Square Inch Rule
This Center Vent Is A Universal Application
The T2/T3 Hood vent is designed to maximize the SCCA T2/T3 class rules around hood vent area height.
199.6 Sq in area including vent framing.
Height: 7/8" Tall vent blades
Dimensions:
17.75" front width
19" Rear Width
12" Tall
Attached is rule:
7. Touring 2 and 3 only: Hoods may have a maximum
of 2 vents installed for cooling purposes.
The maximum combined total area of the vents
shall not exceed 200 square inches. The 200
Square inches includes any area that deviates
from the factory hood profile. Vents may not
protrude above the OEM hood profile more than 25mm (1 inch).
Optimized louver design to maximize extraction flow velocities within a vehicle in motion
Reduces under hood pressure delta to reduce front end lift and increase net vehicle downforce.
Significantly reduces under hood temperatures by extracting heat and allowing fresh cold air to enter the engine bay.
Maximize life of engine accessories by reducing overall operating temperature.
Increases dense, cold air flow through radiator to promote lower coolant temperatures.
Louver backbone design maintains hood structural rigidity.
Installs easily with supplied templates.
Included in kit: Templates for cutting, rivets, washers, installation instructions, and necessary spacers for a factory quality installation.
