2005 - 2023 FORD MUSTANG 14MM R Spec Front Wheel Hub Assemblies With Racing Wheel Stud
***Hubs Have Been Machined to Allow Use of All Wheel Spacers ***
***HUB KITS ARE NEW FORD HUBS WITH STUDS INSTALLED***
***Will Not Fit FRONT 2018+ Mustang GT Performance Pack Level 1 or Level 2 quipped with the MagneRide™ Damping System***
***Verified Fitment on S197 Mustangs - Front Only***
We built this kit with Brand NEW Hub Assemblies with our pre-installed GT350R Length Studs.
A new take on our R Spec wheel studs. These are the same specifications as our direct fit Shelby GT350 R wheel studs with an additional 6mm starting bullet on the end.
This stud will allow the ability to run up to a 50mm spacer which is useful for Customers using 12" wide wheels for Autocross who in the past needed to use bolt-on spacers to achieve proper fitment up front. These studs eliminate the additional failure point created by bolt-on spacers and allows the use of a slip on hub and wheel centric spacer simplifying the clamped connection of the wheel to hub. By design it is more reliable, less failure prone and ultimately safer.
If you are looking to adjust track width of your Mustang to aid turn-in without going to the added expense of custom off-set wheels these studs feature 3.175" of useable thread. For comparison, the 14mm ARP 100-7733 (1" Longer than stock) wheel stud offers 2.5" of useable thread. Due to the design of our studs, which do not have thread where the brake rotor hat attaches actually provides a gain of .900" of extended threaded length on only .675" of additional thread. This is what allows us to fit 50mm spacers vs. a max of 25-28mm spacers on the ARP 100-7733.
UHL (Under Head Length) 4.095" R Spec Bullet vs 3.435" ARP 100-7733 essentially allows us to use twice the spacer while only increasing the total under head stud length by .660"
This kit also meets all sanctioning body requirements for an easy visual inspection of proper lug nut thread engagement by track officials.
Our Studs Are Made In The USA!
The Kit includes 2 FORD Front Hub Assemblies with extended length, 14mm x 1.5 Thread studs.
