Trackspec Mustang S197 Mustang 05-09 GT2 Hood Louvers Kit
Designed specifically for 05-09 S197 Mustang hood lines and low pressure zones behind the radiator and above the wheel arches.
Currently used on multiple winning SCCA/NASA ST2, T1 and GT2 race cars.
Optimized louver design to maximize extraction flow velocities within a vehicle in motion
Reduces under hood pressure delta to reduce front end lift and increase net vehicle downforce.
Significantly reduces under hood temperatures by extracting heat and allowing fresh cold air to enter the engine bay.
Maximize life of engine accessories by reducing overall operating temperature.
Increases dense, cold air flow through radiator to promote lower coolant temperatures.
Louver backbone design maintains hood structural rigidity.
Contoured to fit your specific hood curve.
Installs easily with supplied templates.
Included in kit: Templates for cutting, rivets, washers, installation instructions, and necessary spacers for a factory quality installation.
Powder coated Satin Black for clean appearance and durability.
Dimensions:
Center
13" Height
15" Front Width
20" Rear Width
Side Vents
17" Height
11" Front Width
9" Rear Width
