14MM GT4 Mustang Type Racing Wheel Studs
***NEW 14MM RACING STUD***
***IMSA Style Extended Nose***
This is our newest 14mm Wheel Stud offering.
We teamed up with MSI again to come up with a GT4 Mustang Style Wheel Stud.
This stud will allow the ability to easily run our 31mm spacers. These studs eliminate the additional failure point created by bolt-on spacers and allows the use of a slip on hub and wheel centric spacer simplifying the clamped connection of the wheel to hub. By design it is more reliable, less failure prone and ultimately safer.
UHL (Under Head Length) 3.425" (87MM) vs 3" on the ARP 100-7733.
The extended nose borrowed from IMSA allows our Racing Lug Nuts to fully engage on the wheel stud during tire changes.
The extended shoulder works to better locate the rotor hat and provide added strength to the assembly.
After supplying thousands of wheel studs and building countless wheel hub assemblies we have seen the advantages and shortcomings of the products in the marketplace. Over the past two years we have studied the needs and challenges our Customers have faced with wheel fitments and especially wheel stud failures.
We have set out to design a wheel stud that fits properly, is easy to install, and build tough enough to withstand the loads placed on them from today's vehicles.
We have included pictures to compare our studs to the ARP 100-7733, which is 1" longer than the standard S550 Wheel Stud. We have also included pictures that compare all 3 of our wheel studs.