Cortex Racing Monoball Front Control Arm Kit - 2020 Mustang GT500
***NOTE: THESE WILL NOT FIT GT350 OR OTHER S550 MUSTANGS***
We use Cortex Racing Monoball Assemblies and install them into new Mustang GT500 SPECIFIC OEM Ford Control Arms. We include the Ford Hardware and Instructions so this can be accomplished in less than 30 minutes per side.
These have proven to eliminate deflection in the arm and spindle. On the inside wheel, during a turn the spindle rotates about the caster arm ball joint and pulls the spindle forward increasing caster. Under heavy braking the opposite occurs with the stock rubber bushing as the caster decreases. This deflection in turn creates a toe change which causes the direction changes in the braking zone. The unpredictable feeling of which way the car is going under heavy braking will be solved with these bearings, steering response is also vastly improved because the bearing allows free movement of the arm through it's natural arc. Under heavy loads in fast transition turns, the bearings allow for consistent geometry throughout so your Mustang will go where it is pointed every lap. These bearings will help build driver confidence due to the consistency of the chassis.
If you are running a high grip tire on track these arms will prevent deflection which leads to toe and caster changes under high cornering loads. Spherical Bearings allow for chassis adjustments that are more accurate and do not change during cornering. Due to the spherical bearing design the suspension works better due to the non binding motion of the control arm. Rubber bushings have to twist and deflect, this influences chassis performance and response as the arm moves through its intended arc.
Choose From Our Drop-Down Menu for the option to add the Rear Monoball Kit for the Rear Lower Control Arm
*Note: We Purchase New OEM Ford Arm Assemblies, press out the old bushing, machine the arms to the proper width and install the Cortex Racing Monoball. These are suspension components that perform a function. Because everything is a very tight press fit there will be witness marks and scratches from this process. These products are functional components not show car products. When installed in the vehicle you will not see them.